|
|
PLANET IGS-10020HPT on teollisuuskäyttöön soveltuva 10-
porttinen hallittava L3-tason staattisella reitityksellä
varustettu 10/100/1000 (8x TX + 2x SFP) High PoE
Ethernet -kytkin laajennetulla käyttölämpötila-alueella
sekä DIN-kiskokiinnityksellä.
Kytkin on varustettu "PD keep-alive" ominaisuudella, jolla
kytkin pystyy itsenäisesti tarkistamaan esim. IP-kameran
tilan ping-komennolla ja tekemään portille automaattisen
virtakäynnistyksen (PoE OFF -> PoE ON).
Tekniset tiedot:
8x 10/100/1000BASE-T Gigabit Ethernet RJ45 ports with IEEE
802.3at PoE+ Injector
2x 100/1000/2500BASE-X mini-GBIC/SFP slots for SFP type
auto detection
1x RJ45 console interface for basic management and setup
(IGS-10020HPT)
Complies with IEEE 802.3at Power over Ethernet Plus/end-
span PSE
Up to 8x IEEE 802.3af/802.3at devices powered
Supports PoE power up to 36W for each PoE port
Auto detects powered device (PD)
Circuit protection prevents power interference between
ports
Remote power feeding up to 100m in standard mode and 200m
in extend mode
PoE management features
PoE admin-mode control
PoE management mode selection
Per port PoE function enable/disable
PoE port power feeding priority
Per PoE port power limit
PoE Port Status monitoring
PD classification detection
Sequence port PoE
Intelligent PoE features
PoE Legacy mode enable/disable
Temperature threshold control
PoE usage threshold control
PoE schedule
PD alive check
LLDP PoE Neighbors
Industrial Protocol
Modbus TCP for real-time monitoring in a SCADA system
IEEE 1588v2 PTP (Precision Time Protocol)
Industrial Case and Installation
IP30 aluminum case
DIN rail and wall-mount designs
12-48DCV, redundant power with reverse polarity protection
Supports 6000VDC Ethernet ESD protection
-40...+75C operating temperature
E-Mark certification
2x Digital Input (DI)
2x Digital Output (DO)
Integrate sensors into auto alarm system
Transfer alarm to IP network via email and SNMP trap
Prevents packet loss with back pressure (half-duplex) and
IEEE 802.3x pause frame flow control (full-duplex)
High performance of Store-and-Forward architecture, and
runt/CRC filtering eliminates erroneous packets to optimize
the network bandwidth
Storm Control support
Broadcast/Multicast/Unicast
Supports VLAN
IEEE 802.1Q tagged VLAN
Supports provider Bridging (VLAN Q-in-Q, IEEE 802.1ad)
Private VLAN Edge (PVE)
Port Isolation
MAC-based VLAN
Protocol-based VLAN
Voice VLAN
GVRP
Supports Spanning Tree Protocol
IEEE 802.1D Spanning Tree Protocol (STP)
IEEE 802.1w Rapid Spanning Tree Protocol (RSTP)
IEEE 802.1s Multiple Spanning Tree Protocol (MSTP),
spanning tree by VLAN
BPDU Guard
Supports Link Aggregation
802.3ad Link Aggregation Control Protocol (LACP)
Cisco ether-channel (static trunk)
Maximum 5 trunk groups with 10 ports per trunk group
Up to 20Gbps bandwidth (duplex mode)
Provides port mirror (many-to-1)
Port mirroring to monitor the incoming or outgoing traffic
on a particular port
Loop protection to avoid broadcast loops
Supports ERPS (Ethernet Ring Protection Switching)
Compatible with Cisco Uni-directional link detection(UDLD)
that monitors a link between two switches and blocks the
ports on both ends of the link if the link fails at any
point between the two devices
Link Layer Discovery Protocol (LLDP) and LLDP-MED
Provides ONVIF for co-operating with PLANET video IP
surveillances
Layer 3 IP Routing Features
Supports maximum 32 static routes and route summarization
Quality of Service
Ingress Shaper and Egress Rate Limit per port bandwidth
control
8x priority queues on all switch ports
Traffic classification
IEEE 802.1p CoS
IP TOS/DSCP/IP precedence
IP TCP/UDP port number
Typical network application
Strict priority and Weighted Round Robin (WRR) CoS
policies
Supports QoS and In/Out bandwidth control on each port
Traffic-policing policies on the switch port
DSCP remarking
Multicast
Supports IPv4 IGMP snooping v1, v2 and v3
Supports IPv6 MLD snooping v1 and v2
Querier mode support
IPv4 IGMP snooping port filtering
IPv6 MLD snooping port filtering
Multicast VLAN Registration (MVR) support
Security
Authentication
IEEE 802.1x Port-based/MAC-based network access
authentication
Built-in RADIUS client to co-operate with the RADIUS
servers
TACACS+ login users access authentication
RADIUS/TACACS+ users access authentication
Access Control List
IP-based Access Control List (ACL)
MAC-based Access Control List
Source MAC/IP address binding
DHCP Snooping to filter un-trusted DHCP messages
Dynamic ARP Inspection discards ARP packets with invalid
MAC address to IP address binding
IP Source Guard prevents IP spoofing attacks
IP address access management to prevent unauthorized
intruder
Management
IPv4 and IPv6 dual stack management
Switch Management Interfaces
Console/Telnet Command Line Interface
Web switch management
SNMP v1, v2c, and v3 switch management
SSHv2 and TLSv1.2 secure access
IPv6 IP Address/NTP/DNS management
Built-in Trivial File Transfer Protocol (TFTP) client
BOOTP and DHCP for IP address assignment
System Maintenance
Firmware upload/download via HTTP
Reset button for system reboot or reset to factory default
Dual Images
DHCP Relay
DHCP Option82
DHCP Server Mode support
User Privilege levels control
NTP (Network Time Protocol)
Link OAM
Network Diagnostic
ICMPv6/ICMPv4 Remote Ping
Cable Diagnostic technology provides the mechanism to
detect and report potential cabling issues
SMTP/Syslog remote alarm
Four RMON groups (history, statistics, alarms and events)
SNMP trap for interface Link up and Link down notification
System Log
SFP-DDM (Digital Diagnostic Monitor)
PLANET Smart Discovery Utility for deployment management
PLANET NMS system and CloudViewer for deployment
management