|
|
PLANET IGS-604HPT-M12 on teollisuuskäyttöön suunniteltu
6-porttinen säänkestävä (IP67 + M12 liittimet) hallittava
PoE+ kytkin laajennetulla käyttölämpötila-alueella, jonka
kuudesta portista 4x on varustettu PoE+ virransyöttötuella.
Kytkimeen sopiva M12 kaapeli: PLANET-CB-M12A8MRJ-200
Tekniset tiedot
6x 10/100/1000BASE-T waterproof and dustproof M12
connectors with 4-port IEEE 802.3at/af Power over Ethernet
Injector function
Complies with IEEE 802.3at Power over Ethernet Plus end-
span PSE
Complies with IEEE 802.3af Power over Ethernet end-span
PSE
Up to 4 ports of IEEE 802.3af/802.3at devices powered
Supports PoE Power up to 36 watts for each PoE port
Auto detects powered device (PD)
Circuit protection prevents power interference between
ports
Remote power feeding up to 100 meters
PoE Management
- Total PoE power budget control
- Per port PoE function enable/disable
- PoE Port Power feeding priority
- Per PoE port power limitation
- PD classification detection
- PD alive check
- PoE schedule
- PD scheduled power recycling
IP67-rated aluminum case
Redundant power design
- 48 to 56VDC, redundant power with polarity reverse protect
function
- Active-active redundant power failure protection
- Backup of catastrophic power failure on one supply
- Fault tolerance and resilience
DIN-rail and wall-mount design
Supports 6000V DC Ethernet ESD protection
-40...+75C operating temperature
Supports maximum 32 static routes and route summarization
Prevents packet loss with back pressure (half-duplex) and
IEEE 802.3x pause frame flow control (full-duplex)
High performance of Store-and-Forward architecture, and
runt/CRC filtering that eliminates erroneous packets to
optimize the network bandwidth
Storm control support
- Broadcast/Multicast/Unicast Supports VLAN
- IEEE 802.1Q tagged VLAN
- Up to 255 VLANs groups, out of
4095 VLAN IDs
- Provides Bridging (VLAN Q-in-Q) support (IEEE 802.1ad)
- Private VLAN Edge (PVE)
- Protocol-based VLAN
- MAC-based VLAN
- IP subnet-based VLAN
- Voice VLAN
Supports Spanning Tree Protocol
- IEEE 802.1D Spanning Tree Protocol (STP)
- IEEE 802.1w Rapid Spanning Tree Protocol (RSTP)- IEEE
802.1s Multiple Spanning Tree Protocol (MSTP), spanning tree
by VLAN
- BPDU Guard
Supports Link Aggregation
- 802.3ad Link Aggregation Control Protocol (LACP)
- Cisco ether-channel (static trunk)
- Maximum 3 trunk groups, with 2 ports for each trunk
- Up to 4Gbps bandwidth (full duplex mode)
Provides port mirror (many-to-1)
Port mirroring monitors the incoming or outgoing traffic
on a particular port
Loop protection to avoid broadcast loops
Supports E.R.P.S. (Ethernet Ring Protection Switching)
IEEE 1588 and synchronous Ethernet network timing
Ingress shaper and egress rate limit per port bandwidth
control
8x priority queues on all switch ports
Traffic classification
- IEEE 802.1p CoS
- ToS/DSCP/IP precedence of IPv4/IPv6 packets
- IP TCP/UDP port number
- Typical network application
Strict priority and Weighted Round Robin (WRR) CoS
policies
Traffic-policing policies on the switch port
DSCP remarking
Supports IGMP snooping v1, v2 and v3
Supports MLD snooping v1 and v2
Querier mode support
IGMP snooping port filtering
MLD snooping port filtering
MVR (Multicast VLAN Registration)
Authentication
- IEEE 802.1x port-based/MAC-based network access
authentication
- IEEE 802.1x authentication with guest VLAN
- Built-in RADIUS client to cooperate with the RADIUS
servers
- RADIUS/TACACS+ users access authentication
Access Control List
- IP-based Access Control List (ACL)
- MAC-based Access Control List (ACL)
Source MAC/IP address binding
DHCP Snooping to filter distrusted DHCP messages
Dynamic ARP Inspection discards ARP packets with invalid
MAC address to IP address binding
IP Source Guard prevents IP spoofing attacks
IP address access management to prevent unauthorized
intruder
IPv4 and IPv6 dual stack management
Switch Management Interfaces
- Telnet command line interface
- Web switch management
- SNMP v1, v2c, and v3 switch management
- SSH/SSL secure access
IPv6 address/NTP management
Built-in Trivial File Transfer Protocol (TFTP) client
BOOTP and DHCP for IP address assignment
System Maintenance
- Firmware upload/download via HTTP/TFTP
- Reset button for system reboot or reset to factory default
- Dual images
DHCP relay and option 82
User privilege levels control
NTP (Network Time Protocol)
Link Layer Discovery Protocol (LLDP) and LLDP-MED
Network diagnostic
- Cable diagnostic technology provides the mechanism to
detect and report potential cabling issues
- ICMPv6/ICMPv4 remote ping
SMTP/Syslog remote alarm
Four RMON groups (history, statistics, alarms and events)
SNMP trap for interface link up and link down notification
System Log
PLANET Smart Discovery Utility for deployment management