|
PLANET IGS-6325-24P4X on teollisuuskäyttöön suunniteltu
28-porttinen hallittava 19" Ethernet PoE+ -kytkin
laajennetulla käyttölämpötila-alueella.
Layer 3 -tason kytkin on varustettu 24x 10/100/1000Base-T
PoE+ -kupariportilla, 4x jaetulla 100/1000Base-X SFP-
moduulipaikalla sekä 4x 10GBaseSR/LR SFP+ -portilla.
Kytkimessä on lisäksi kehittyneemmät hallintapuolen
turvaominaisuudet sekä IEEE 1588v2 PTP -aikaprotokollatuki
aikakriittisisiin sovelluksiin.
Tekniset tiedot
• 24x 10/100/1000BASE-T Gigabit Ethernet RJ45 ports with
IEEE 802.3at PoE+ Injector function
• 4x 100/1000BASE-X SFP slots, shared with Port-21
to Port-24 compatible with 100BASE-FX SFP
• 4x 10GBASE-SR/LR SFP+ slots, compatible with 1000BASE-
SX/LX/BX SFP
• RJ45 to RS232 DB9 console interface for basic management
and setup
• Complies with IEEE 802.3at Power over Ethernet Plus/end-
span PSE
• Up to 24x IEEE 802.3at devices powered
• Supports PoE power up to 36W for each PoE port
440W PoE budget
• Auto detects powered device (PD)
• Circuit protection prevents power interference between
ports
• Remote power feeding up to 100m
• PoE management features
- Total PoE power budget control
- Per port PoE function enable/disable
- PoE admin-mode control
- PoE port power feeding priority
- Per PoE port power limit
- PD classification detection
• Intelligent PoE features
- Temperature threshold control
- PoE usage threshold control
- PD alive check
- PoE schedule
• Modbus TCP for real-time monitoring in the SCADA system
• IEEE 1588v2 PTP (Precision Time Protocol)
• IP30 metal case protection
• 19" rack-mountable design
• Dual 48...56VDC, redundant power with polarity reverse
protect function
• Active-active redundant power failure protection
• Backup of catastrophic power failure on one supply
• Fault tolerance and resilience
• Supports EFT protection for 6kVDC power and 5kVDC Ethernet
ESD protection
• -40...+75C operating temperature
• 2x digital input (DI)
• 2x digital output (DO)
• Integrate sensors into auto alarm system
• Transfer alarm to IP network via email and SNMP trap
• Prevents packet loss with back pressure (half-duplex) and
• IEEE 802.3x pause frame flow control (full-duplex)
• High performance of Store-and-Forward architecture, and
runt/CRC filtering eliminates erroneous packets to optimize
the network bandwidth
• Storm Control support
• Broadcast/Multicast/Unicast
• Supports VLAN
- IEEE 802.1Q tagged VLAN
- Up to 256 VLANs groups, out of 4096 VLAN IDs
- Provider Bridging (VLAN Q-in-Q) support (IEEE 802.1ad)
- Private VLAN Edge (PVE)
- Protocol-based VLAN
- MAC-based VLAN
- Voice VLAN
- GVRP (GARP VLAN Registration Protocol)
• Supports Spanning Tree Protocol
- IEEE 802.1D Spanning Tree Protocol (STP)
- IEEE 802.1w Rapid Spanning Tree Protocol (RSTP)
- IEEE 802.1s Multiple Spanning Tree Protocol (MSTP),
spanning tree by VLAN
- BPDU Guard
• Supports Link Aggregation
- 802.3ad Link Aggregation Control Protocol (LACP)
- Cisco ether-channel (static trunk)
- Maximum 14 trunk groups with 16 ports per trunk group
- Up to 32Gbps bandwidth (duplex mode)
• Provides port mirror (many-to-1)
• Port mirroring to monitor the incoming or outgoing traffic
on a particular port
• Loop protection to avoid broadcast loops
• Supports ERPS (Ethernet Ring Protection Switching)
• Compatible with Cisco Uni-directional link detection
(UDLD) that monitors a link between two switches and blocks
the ports on both ends of the link if the link fails at any
point between the two devices
• Link Layer Discovery Protocol (LLDP)
• Layer 3 IP Routing Features
• Supports maximum 128 static routes and route summarization
IPv4 dynamic routing protocol supports OSPFv2
• IPv4/IPv6 hardware static routing
• Routing interface provides per VLAN routing mode
• Ingress Shaper and Egress Rate Limit per port bandwidth
control
• 8x priority queues on all switch ports
• Traffic classification
- IEEE 802.1p CoS
- IP TOS/DSCP/IP precedence
- IP TCP/UDP port number
- Typical network application
• Strict priority and Weighted Round Robin (WRR) CoS
policies
• Traffic-policing on the switch port
• DSCP remarking
• Multicast
• Supports IPv4 IGMP snooping v1, v2 and v3
• Supports IPv6 MLD snooping v1 and v2
• Querier mode support
• IPv4 IGMP snooping port filtering
• IPv6 MLD snooping port filtering
• MVR (Multicast VLAN Registration)
• Authentication
- IEEE 802.1x port-based / MAC-based network access
authentication
- Built-in RADIUS client to co-operate with the RADIUS
servers
- TACACS+ login users access authentication
- RADIUS / TACACS+ users access authentication
• Access Control List
- IP-based Access Control List (ACL)
- MAC-based Access Control List
• Source MAC / IP address binding
• DHCP Snooping to filter un-trusted DHCP messages
• Dynamic ARP Inspection discards ARP packets with invalid
• MAC address to IP address binding
• IP Source Guard prevents IP spoofing attacks
• IP address access management to prevent unauthorized
intruder
• IPv4 and IPv6 dual stack management
• Switch Management Interfaces
• Console/Telnet Command Line Interface
• Web switch management
• SNMP v1 and v2c switch management
• SSH, TLS, SSL and SNMP v3 secure access
• SNMP Management
• Four RMON groups (history, statistics, alarms, and events)
• SNMP trap for interface Link Up and Link Down notification
• IPv6 IP address/NTP/DNS management
• Built-in Trivial File Transfer Protocol (TFTP) client
• BOOTP and DHCP for IP address assignment
• System Maintenance
• Firmware upload/download via HTTP/TFTP
• Reset button for system reboot or reset to factory default
• Dual Images
• DHCP Relay and DHCP Option 82
• DHCP Server
• User Privilege levels control
• Network Time Protocol (NTP)
• SFP-DDM (Digital Diagnostic Monitor)
• Network Diagnositc
• ICMPv6/ICMPv4 Remote Ping
• Cable diagnostic technology provides the mechanism to
detect and report potential cabling issues
• PLANET Smart Discovery Utility for deployment management
• SMTP/Syslog remote alarm
• System Log
