|
|
PLANET IGS-4215-16P2T2S on teollisuuskäyttöön suunniteltu
20-porttinen hallittava 10/100/1000 PoE+ Ethernet-kytkin
laajennetulla käyttölämpötila-alueella
sekä DIN-kiskokiinnityksellä. Kytkin on varustettu 18x
10/100/1000Base-T portilla, joista 16x varustettu PoE+
virransyöttötuella. Kytkimessä on lisäksi 2x SFP-
modulipaikkaa valokuitumoduuleille.
Kytkin on varustettu "PD keep-alive" ominaisuudella, jolla
kytkin pystyy itsenäisesti tarkistamaan esim. IP-kameran
tilan ping-komennolla ja tekemään portille automaattisen
virtakäynnistyksen (PoE OFF -> PoE ON).
Tekniset tiedot:
16x 10/100/1000BASE-T Gigabit Ethernet RJ45 ports with
IEEE 802.3at/af PoE+ Injector function
2x 10/100/1000BASE-T Gigabit Ethernet RJ45 ports
2x 100/1000BASE-X SFP slots for SFP type auto detection
One RJ45 console interface for basic management and setup
Complies with IEEE 802.3at Power over Ethernet Plus, end-
span PSE
Backward compatible with IEEE 802.3af Power over Ethernet
Up to 16 ports of IEEE 802.3af/802.3at devices powered
320W PoE budget
Supports PoE power up to 36 watts for each PoE port
Auto detects powered device (PD)
Circuit protection prevents power interference between
ports
Remote power feeding up to 100 meters in standard mode and
250m in extend mode
PoE management
- Total PoE power budget control
- Per port PoE function enable/disable
- PoE port power feeding priority
- Per PoE port power limitation
- PD classification detection
Intelligent PoE features
- Temperature threshold control
- PoE extension
- PD alive check
- PoE schedule
Industrial Case and Installation
- IP30 aluminum case
- DIN rail and wall-mount design
- 48...54VDC, redundant power with reverse polarity
protection
Supports 6000V DC Ethernet ESD protection
-40 to 75 degrees C operating temperature
Digital Input and Digital Output
- 2 digital input (DI)
- 2 digital output (DO)
Integrate sensors into auto alarm system
Transfer alarm to IP network via SNMP trap
Hardware-based 10/100Mbps (half/full duplex), 1000Mbps
(full duplex), auto-negotiation and auto MDI/MDI-X
IEEE 802.3x flow control for full duplex operation and
back pressure for half duplex operation
8K MAC address table size
10K jumbo frame
Automatic address learning and address aging
Supports VLAN
- IEEE 802.1Q tagged VLAN
- Provider bridging (VLAN Q-in-Q, IEEE 802.1ad) support
Protocol VLAN
- Voice VLAN
- Private VLAN (Protected port)
- Management VLAN
GVRP
Supports Spanning Tree Protocol
- STP (Spanning Tree Protocol)
- RSTP (Rapid Spanning Tree Protocol)
- MSTP (Multiple Spanning Tree Protocol)
- STP BPDU Guard, BPDU Filtering and BPDU Forwarding
Supports Link Aggregation
- IEEE 802.3ad Link Aggregation Control Protocol (LACP)
- Cisco ether-channel (static trunk)
- Maximum 8 trunk groups, up to 8 ports per trunk group
Provides port mirror (many-to-1)
Loop protection to avoid broadcast loops
Supports ERPS (Ethernet Ring Protection Switching)
Link Layer Discovery Protocol (LLDP)
Ingress/Egress Rate Limit per port bandwidth control
Traffic classification
IEEE 802.1p CoS
TOS/DSCP/IP precedence of IPv4/IPv6 packets
Strict priority and Weighted Round Robin (WRR) CoS
policies
Supports IPv4 IGMP snooping v2, v3
Supports IPv6 MLD snooping v1, v2
IGMP querier mode support
IGMP snooping port filtering
MLD snooping port filtering
Storm Control support
Broadcast/ unknown multicast/unknown unicast
Authentication
- IEEE 802.1X port-based network access authentication
- Built-in RADIUS client to cooperate with the RADIUS
servers
- DHCP Option 82
- RADIUS/TACACS+ authentication
- Access Control List
- IPv4/IPv6 IP-based ACL
- IPv4/IPv6 IP-based ACE
- MAC-based ACL
- MAC-based ACE
MAC Security
- Static MAC
- MAC filtering
- Port security for source MAC address entries filtering
DHCP snooping to filter distrusted DHCP messages
Dynamic ARP inspection discards ARP packets with invalid
MAC address to IP address binding
IP source guard prevents IP spoofing attacks
DoS attack prevention
Management
- IPv4 and IPv6 dual stack management
- Switch Management Interface
- Web switch management
- Console/Telnet Command Line Interface
- SNMP v1 and v2c switch management
- SSHv2, TLSv1.2 and SNMP v3 secure access
- SNMP Management
- SNMP trap for interface Link Up and Link Down notification
- Four RMON groups (history, statistics, alarms and events)
User privilege levels control
Built-in Trivial File Transfer Protocol (TFTP) client
Static and DHCP for IP address assignment
System Maintenance
Firmware upload/download via HTTP/TFTP
Configuration upload/download through HTTP/TFTP
Dual images
Hardware reset button for system reboot or reset to
factory default
SNTP Network Time Protocol
Network Diagnostic
Cable diagnostics
ICMPv6/ICMPv4 Remote Ping
SFP-DDM (Digital Diagnostic Monitor)
Link Layer Discovery Protocol (LLDP) Protocol and LLDP-MED
Event message logging to remote syslog server
PLANET Smart Discovery Utility for deployment management
PLANET NMS system and CloudViewer/CloudViewerPro for
deployment management