Microdata Finland Oy - Tietoliikennetukkuri


Valmistajat

16x1000T@16xPoE+, 2xSFP, Managed
Tuotekoodi: PLANET-IGS-20160HPT
Valmistajan koodi: IGS-20160HPT
Tuotteen nimi: 16x1000T@16xPoE+, 2xSFP, Managed
-40...+75C, IP30, DI/DO, DIN
Tuoteryhmä: Industrial PoE
Valmistaja: PLANET Technology
Viivakoodi: 4711605281751
Takuuaika 24 kk
Lisätiedot: Avaa tuotesivu
Tuote-esite
Lataa käsikirja / asennusohje
Pika-asennusopas (QIC)
Myyntiopas
PLANET-IGS-20160HPT


PLANET IGS-20160HPT on teollisuuskäyttöön soveltuva 20-
porttinen hallittava L3-tason 10/100/1000 (16x PoE + 2x TX +
2x SFP) High PoE Ethernet -kytkin laajennetulla
käyttölämpötila-alueella sekä DIN-kiskokiinnityksellä.

Kytkin on varustettu "PD keep-alive" ominaisuudella, jolla
kytkin pystyy itsenäisesti tarkistamaan esim. IP-kameran
tilan ping-komennolla ja tekemään portille automaattisen
virtakäynnistyksen (PoE OFF -> PoE ON).

Tekniset tiedot:
  16x 10/100/1000BASE-T Gigabit Ethernet RJ45 ports with
IEEE 802.3at PoE+ Injector
  2x 10/100/1000BASE-T Gigabit Ethernet RJ45 ports
  2x 100/1000/2500BASE-X mini-GBIC/SFP slots for SFP type
auto detection
  One RJ45 console interface for basic management and setup
  Complies with IEEE 802.3at Power over Ethernet Plus/end-
span PSE
  Up to 16 IEEE 802.3af/802.3at devices powered
  Supports PoE power up to 36 watts for each PoE port
  Auto detects powered device (PD)
  Circuit protection prevents power interference between
ports
  Remote power feeding up to 100m in standard mode; 250m in
extended mode at speed of 10Mbps
  PoE management features
  PoE admin-mode control
  PoE management mode selection
  PoE Legacy mode selection
  PoE Budget setup option
  Per port PoE function enable/disable
  PoE port power feeding priority
  Per PoE port power limit
  PoE Port Status monitoring
  PD classification detection
  Sequence port PoE
  Intelligent PoE features
  Temperature threshold control
  PoE usage threshold control
  PoE extension
  PoE schedule
  PD alive check
  LLDP PoE Neighbors
  Industrial Protocol
  Modbus TCP for real-time monitoring in the SCADA system
  IEEE 1588v2 PTP (Precision Time Protocol)
  Industrial Case and Installation
  IP30 aluminum case
  DIN-rail or wall-mount design
  48...56VDC, redundant power with reverse polarity
protection
  Supports 6kVDC Ethernet ESD protection
  -40...+75C operating temperature
  Digital Input and Digital Output
  2x digital input (DI)
  2x digital output (DO)
  Integrate sensors into auto alarm system
  Transfer alarm to IP network via email and SNMP trap
  Layer 2 Features
  Prevents packet loss with back pressure (half-duplex) and
IEEE 802.3x pause frame flow control (full-duplex)
  High performance of Store-and-Forward architecture, and
runt/CRC filtering eliminates erroneous packets to optimize
the network bandwidth
  Storm Control support
  Broadcast/Multicast/Unicast
  Supports VLAN
  IEEE 802.1Q tagged VLAN
  Up to 4K VLANs groups, out of 4094 VLAN IDs
  Supports provider bridging (VLAN Q-in-Q, IEEE 802.1ad)
  Private VLAN Edge (PVE)
  Port Isolation
  MAC-based VLAN
  IP Subnet-based VLAN
  Protocol-based VLAN
  VLAN Translation
  Voice VLAN
  GVRP
  Supports Spanning Tree Protocol
  IEEE 802.1D Spanning Tree Protocol (STP)
  IEEE 802.1w Rapid Spanning Tree Protocol (RSTP)
  IEEE 802.1s Multiple Spanning Tree Protocol (MSTP),
spanning tree by VLAN
  BPDU Filtering/BPDU Guard
  Supports Link Aggregation
  802.3ad Link Aggregation Control Protocol (LACP)
  Cisco ether-channel (static trunk)
  Maximum 10 trunk groups with 4 ports per trunk group
  Up to 8Gbps bandwidth (duplex mode)
  Provides port mirror (1-to-1)
  Port mirroring to monitor the incoming or outgoing traffic
on a particular port
  Loop protection to avoid broadcast loops
  Supports ERPS (Ethernet Ring Protection Switching)
  Compatible with Cisco Uni-directional link detection
(UDLD) that monitors a link between two switches and blocks
the ports on both ends of the link if the link fails at any
point between the two devices
  Link Layer Discovery Protocol (LLDP)
  Provides ONVIF for co-operating with PLANET video IP
surveillances
  Layer 3 IP Routing Features
  Supports maximum 128 static routes and route summarization
  IPv4 dynamic routing protocol supports OSPFv2
  IPv4/IPv6 hardware static routing
  Routing interface provides per VLAN routing mode
  Quality of Service
  Ingress Shaper and Egress Rate Limit per port bandwidth
control
  8x priority queues on all switch ports
  Traffic classification
  IEEE 802.1p CoS
  IP TOS/DSCP/IP precedence
  IP TCP/UDP port number
  Typical network application
  Strict priority and Weighted Round Robin (WRR) CoS
policies
  Supports QoS and In/Out bandwidth control on each port
  Traffic-policing on the switch port
  DSCP remarking
  Multicast
  Supports IPv4 IGMP snooping v1, v2 and v3
  Supports IPv6 MLD snooping v1 and v2
  Querier mode support
  IPv4 IGMP snooping port filtering
  IPv6 MLD snooping port filtering
  MVR (Multicast VLAN Registration)
  Security
  Authentication
  IEEE 802.1x port-based / MAC-based network access
authentication
  Built-in RADIUS client to co-operate with the RADIUS
servers
  TACACS+ login users access authentication
  RADIUS / TACACS+ users access authentication
  Access Control List
  IP-based Access Control List (ACL)
  MAC-based Access Control List
  Source MAC / IP address binding
  DHCP Snooping to filter un-trusted DHCP messages
  Dynamic ARP Inspection discards ARP packets with invalid
  MAC address to IP address binding
  IP Source Guard prevents IP spoofing attacks
  IP address access management to prevent unauthorized
intruder
  Management
  IPv4 and IPv6 dual stack management
  Switch Management Interfaces
  Web switch management
  Console/Telnet Command Line Interface
  SNMP v1 and v2c switch management
  SSHv2, TLSv1.2 and SNMP v3 secure access
  IPv6 IP Address/NTP/DNS management
  Built-in Trivial File Transfer Protocol (TFTP) client
  BOOTP and DHCP for IP address assignment
  System Maintenance
  Firmware upload/download via HTTP
  Reset button for system reboot or reset to factory default
  Dual Images
  DHCP Relay
  DHCP Option82
  DHCP Server
  User Privilege levels control
  NTP (Network Time Protocol)
  UPnP
  Link Layer Discovery Protocol (LLDP) and LLDP-MED
  IEEE 802.3ah OAM
  Compatible with Cisco uni-directional link detection(UDLD)
that monitors a link between two switches and blocks the
ports on both ends of the link if the link fails at any
point between the two devices
  Network Diagnostic
  SFP-DDM (Digital Diagnostic Monitor)
  ICMPv6/ICMPv4 Remote Ping
  Cable Diagnostic technology provides the mechanism to
detect and report potential cabling issues
  SMTP/Syslog remote alarm
  Four RMON groups (history, statistics, alarms and events)
  SNMP trap for interface Linkup and Linkdown notification
  System Log
  PLANET NMS System and Smart Discovery Utility for
deployment management


Tuotteeseen liittyviä muita tuotteita: